DMA/CAMCO---REQUEST FOR CAMCO DIAL QUOTATION

Fields marked with an " * " are required for successful submission

Name: *
E-mail Address: *
Project Manager:  
Mechanical Manager: *
Project # / Description:  
Assembly #/Description: *
Station #/ Description:  
Application Data
Dial Plate Material:      Alum.   Steel  (check one that applies)
Diameter of Dial Plate   = *
Thickness of Dial Plate (Y)     = *
Number of Stations (S)      =  *
Weight of Each Station    = *
Radius to Station Center     = *in.
Accuracy Req'd @*Inch Radius...= *in.
Dwell Time      = *sec.
Index Time      = *sec.
Total Cycle Time *sec.
Engineer: *
 
Cycle, On Demand or Continuous Duty: *
Stationary Post: *
Imperial/Metric: *
Will output shaft be mounted vertical up? *
Will there be a lot of emergency stops? *
Will the dial be supported by an outboard bearing, runners or guides? *
Will the dial be subjected to any forces from robots, welding machines, tooling, e.t.c? *
Will the indexer be driving anything other-than the dial? *
Accuracy/Repeatability at what radius? *

    

Please E-mail & attach a drawing of dial and tooling if available to rjplourde@sympatico.ca

Ontario, Quebec, Maritimes

Designed Methods of Automation

22 Garside Crescent, Brampton, Ontario, L6S 1H6

Phone: 905-459-5248 Fax: 905-459-0428 Cell: 905-965-1536

Email: rjplourde@sympatico.ca

Robert J. Plourde - Jo-Anne Plourde